Cli-mate CLI-AP30 Spezifikationen PDF herunterladen (Seite 32)

b) If installed in a direct flow system or closed loop using a brazed plate heat exchanger (BPHE) an inline

strainer should be fitted before the pump to catch any sediment and allow periodic clean out.

3.31. Supporting Pipe and System Components

a) Pipe hangers use to support system components should be able to support the

components and maintain the proper pitch. Any hangers used should not compress

insulation used.

3.32. Heat Transfer Fluids

a) Heat transfer fluids are required in areas that routinely experience freezing

temperatures.

b) There are several types of heat transfer fluids commercially available, each with

different properties. The following table provides a summary of key features of common

fluids with water as base comparison. Please refer to detailed data files offered by each

manufacturer. Apricus makes no claims on the performance of the products listed below.

Apricus Solar Collector Installation & Operation Manual - USA

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 119 120

Keine Kommentare

Cli-mate CLI-AP30 Spezifikationen Seite 32